28
8 Micro-SIM card holder (set the card‘s PIN to 1513!)
9 „ERR“ LED (red)
10 „GPS“-LED (blue)
11 Screw connection
12 Position of the GPS receiver in the housing
9. Getting Started
Step 1: Remove all 4 screws and take off the two protective caps.
The seals may fall from the cap. Keep them for assembly.
Step 2: Pull the PCB from the housing at the rear. Remember how the PCB was inserted
into the housing. Hold the PCB only by the edge if possible.
Step 3: Connect the rechargeable batters to the bottom of the PCB (next to the SIM
holder).
Step 4: Push the PCB and the rechargeable battery into the housing. Observe the con-
nection cable to ensure that it is not crushed/damaged.
Step 5: Put on the rear cap and screw it on.
Observe that the seal is properly inserted into the lid. It should run along the edge and
not have any cracks.
The rear cap has a spacer to fasten the smaller rechargeable battery in the housing. The
cap should easily push the rechargeable battery through to the front. If you encounter
any resistance, repeat steps 2 and 3.
If the cap cants when pushed or screwed on (rechargeable battery is com-
pressed), part of the spacer may be shortened, e.g. with a wire cutter.