Renishaw HPGA, Инструкция по установке и эксплуатации

Страница: 19 / 40

17
Hub and base adjustment
1. Rotate arm on bottom mounting
screw to set stylus alignment.
2. Tighten all screws to 10 Nm.
3. Check that stylus alignment has
not moved after tightening.
4. If required, dowel base in position.
Drill through base into mounting
using pilot holes as a guide. Fit
roll pins supplied in base fixing kit.
Apply corrosion inhibitor to pins
after fitting.
Roll pin
(Ø6 x 22)
23
21
Drill Ø 6.12
6.00
System installation
1° 1°
Conduit installation
1. Loosely fit the O-clip over the
conduit.
2. Push the conduit over the barbed
conduit fitting and position the
O-clip.
3. Pinch the O-clip onto the conduit
using pincers.
NOTE:
The procedure is similar for
conduit installation on 90 degree
connectors.
Conduit
O-clip
Conduit fitting