Renfert
13 Drain the unit
Easyclean MD
23 / 28
The Remaining time and Heating symbols will be shown on the display (if saved).
The remaining time, the current temperature and the ultrasound mode are continu-
ously shown on the display.
IMPORTANT
Depending on the settings saved in the programme, ultrasonic clean-
ing is started with auto-degas (degas flashes) or Temperature-controlled start
(only
starts once the target temperature has been reached). The respective symbols are
shown on the display.
The end of cleaning is indicated by the
End of cleaning
symbol and, where applic-
able, an acoustic signal (depending on the parameter settings). The Remaining time
display will disappear.
12.10
Switch off and save
For information on saving programmes, see Save programmes [
The displayed settings are saved when the unit is switched off and are then available the next
time the unit is switched on. This function cannot be used to save
Auto-degas
and
Temperature-
controlled start
.
Press the
On/off
button to switch off the unit. Any settings made will be saved until
the next time the unit is switched on.
12.11
Remove cleaned objects
ü
The end of ultrasonic cleaning is indicated by the
End of cleaning
symbol or, where applicable,
an acoustic signal.
1. Carefully remove the lid, and allow any dripping water to drip into the tank. Then, place the lid
upside down next to the unit to use as a drip tray.
CAUTION! If using high cleaning temperatures > 50 °C, allow the fluid to cool first or
use suitable heat-resistant protective gloves.
2. Lift the basket or insert out of the tank, allow the excess fluid to drain briefly, and place it on the
upturned lid.
ð
The objects are now clean. Check the cleaning result.
è
Check the fill level if you intend to start a further ultrasonic cleaning process.
è
Switch off the unit. If the fluid is dirty or will not be used again, empty out the liquid. See the sec-
tion
Drain the unit
for information.
13 Drain the unit
CAUTION
Hot fluid
Danger of burns and scalds caused by spilled fluid!
Ø
Allow the fluid to cool.
Ø
Unplug the mains plug.
Drain the unit:
ü
Ultrasound operation has finished.
