Renesas SDI Emulator System M32100T-EZ-E, Руководство пользователя

Страница: 21 / 44

( 19 / 42 )
(2) Names and Functions of Parts on the Side Panel
Figure 2.3 Name of each part on the side panel
1. Reset control switch
The reset control switch selects the status of the /RESET signal to the target MCU after the
emulator power is turned on until the emulator debugger gets started. Table 2.3 shows the switch
functions.
It is always recommended to set this switch to LOW.
Table 2.3 Functions of the reset control switch
Reset control switch
Setting
Hi-z
LOW
/RESET signal to the target MCU
High impedance (MCU on the target board enabled.)
Fixed to low level (MCU on the target board reset.)
(3) Names and Functions of Parts on the Front Panel
Figure 2.4 Name of each part on the front panel
1. SDI MCU control interface connector
The target MCU control signals used for the emulator with JTAG connection are assigned on the
SDI MCU control interface connector. For connecting the target board, use the included SDI
MCU control interface cable.
For details, refer to "3.2 Connecting the Target System" (page 23).
SDI MCU control interface connector