Renesas PC7501, Руководство пользователя

Страница: 32 / 50

PC7501 User’s Manual 4. Setup
R20UT0207EJ0500 Rev.5.00 Page 32 of 50
Nov 01, 2010
IMPORTANT
If the LAN interface is used as the PC7501 communication interface, it is necessary to acquire an IP address of the
PC7501. For details, contact your network administrator.
IMPORTANT
To register network information, shut power to the PC7501 OFF and restart. The registered information is activated by
restarting the PC7501.
IMPORTANT
The PC7501 cannot communicate with more than one host machine at a time. It communicates with the first host
machine to which the PC7501 is connected.
IMPORTANT
The initial values of network information for the PC7501 are as follows.
IP address: 39.40.41.44
Subnet mask: 255.255.255.255
Port number: 7500 Gateway: 255.255.255.255 (not in use)
(2) Using the SETIP.EXE
If you use the emulator debugger M3T-PDxxF on Windows 95 or Windows NT 4.0, the SETIP.EXE cannot be used. In
this case, register the network information by using the emulator debugger M3T-PDxxF referring "(1) Using the
emulator debugger M3T-PDxxF" (P.31).
Use the utility software SETIP.EXE, which is accompanied by the emulator debugger M3T-PDxxF, to register the
network information of the emulator PC7501 by use of the LAN interface.
When the registration of the network information in the emulator PC7501 is completed, you can connect the emulator
debugger M3T-PDxxF to the emulator PC7501 by use of the LAN interface.
The setup procedure is as follows.
Turn power to the host machine, PC7501 and target system OFF.
Connect a 10BASE-T cable to the LAN interface connector of the PC7501.
Switch the interface selection switch on the rear panel to "LAN."
Turn ON the power to the host machine and then turn ON the power of the PC7501 and the target
system as simultaneously as possible.
Start up SETIP.EXE and register network information in the PC7501 as specified in "Setting of the
LAN Interface using the SETIP.EXE" of the emulator debugger M3T-PDxxF user's manual (or
Online Help).
Turn power to the PC7501 and target system OFF.
Turn ON the power of the PC7501 and the target system as simultaneously as possible.
Start up the emulator debugger M3T-PDxxF (select LAN on the MCU tab of the Init dialog box, the
IP address and port number). However, it is not necessary to set the IP address of the gateway.