Renesas PC7501, Руководство пользователя

Страница: 27 / 50

PC7501 User’s Manual 4. Setup
R20UT0207EJ0500 Rev.5.00 Page 27 of 50
Nov 01, 2010
4.2.1 Connecting by LPT Parallel Interface
The procedure to set up your system using the LPT parallel interface is shown below.
Turn OFF the power to the host machine and emulator PC7501.
Set the interface selection switch on the rear panel to "LPT."
3.2.1 Interface Selection Switch (P.22)
Connect the LPT parallel interface cable to the printer port of the host machine.
T T
Figure 4.2 Connecting the LPT parallel interface cable (host machine side) (P.28)
Fasten the cable to the host machine using the screws of the cable.
Connect the cable to the LPT parallel interface connector on the emulator PC7501.
T T
Figure 4.3 Connecting the LPT parallel interface cable (emulator PC7501 side) (P.28)
Connect the emulation probe M3xxxxTx-EPB or R0ExxxxxxEPB00 to the connector on the emulator
PC7501.
T T
4.3 Connecting Emulation Probe M3xxxxTx-EPB or R0ExxxxxxEPB00 (P.35)
Connect the emulation probe M3xxxxTx-EPB or R0ExxxxxxEPB00 and the target system.
T T
See the user's manual of the emulation probe
Turn ON the power to the host machine and then turn ON the power of the PC7501 and the target
system as simultaneously as possible.