M-Station Baseboard
9.2.4
Flash Programming Command Buttons
There are six flash-programming command buttons:
•
Program Sequence
that executes erase, program, and verify commands in sequence
•
Ssig Chk
that checks and shows the device’s silicon signature
•
Blank Chk
that checks whether the device is Blank (erased) or Not Blank (programmed)
•
Write
that programs the selected user program file into flash memory
•
Erase
that erases the flash device’s memory
•
Verify
that compares the user program file to the contents of the flash device’s memory
9.2.4.1 Program
Sequence
Clicking the
Program Sequence
command button causes the program to
1. Power up and initialize the device, and then check the signature against the .PRC file
2. Run a Blank Check to determine whether the device needs to be erased before
programming
3. Executes an Erase operation if the device needs to be erased
4. Performs a Write operation to program the device with the selected file
5. Finishes with a Verify operation to check programming after the device is written
During the
Program Sequence
, the Status window displays the operation being performed and its
progress. At the end of the sequence, the Status window should show “Written and verified”.
55
Содержание M-Station
Страница 4: ...M Station Baseboard ii...
Страница 8: ...M Station Baseboard vi...
Страница 11: ...M Station Baseboard 3 HARDWARE Figure 1 M Station Baseboard Figure 2 Board Layout 3...
Страница 81: ...M Station Baseboard 73...
