Renesas H8 Series, Руководство пользователя

Страница: 206 / 272

184
[General] page (cont)
[Break on access error] When this box is checked, a break (the user program stops) occurs if
your program accesses an access-prohibited area or writes to a write-
protected area.
[Enable internal ROM area write] When this box is checked, writing to the internal ROM area is enabled.
For the result of writing, see the [Extended Monitor] window.
[Transit to active mode at break] Checking this box causes the emulator to enter the active mode when a
break occurs if the emulator has been in the subactive mode immediately
before the occurrence of a break. This allows a break processing by the
system clock.
[User VCC Threshold] Sets the voltage level for the user system. [Down] will be displayed in
[User System Voltage] of the [Extended Monitor] window when the actual
user VCC of the target system is lower than the specified value.
[User Signals] When this box is checked, the reset and NMI signals from the user
system are enabled.
[Driver] Displays the E6000 driver that is currently installed.
[Change driver in start up] When this box is checked, selection of a driver will be available next time
the emulator is connected.
The MCUs selectable by the [Device] option and options that depend on the MCUs are listed below. To emulate
an MCU with a description in the Expansion Hardware column, connect the correct expansion hardware.