1AB8651.0
Reconnect the computer and the air bag ignition module, then switch on the
ignition again. Erase the computer memory, then switch off the ignition. Carry
out a check using the fault finding tool and, in the absence of a fault , unlock the
computer. Destroy the air bag if there has been a replacement (tool ELE 1287).
AFTER REPAIR
DF003
present
CONT
None
NOTES
CC.1 - CC.0
Lock the computer using the fault finding tool command.
Switch off the ignition and remove the two steering wheel boss mounting bolts.
Check the condition of the trigger cable.
The XRBAG must be used for insulation measurement appropriate to the type of fault at point C2 of the
driver’s front air bag circuit.
If the value obtained is not correct, replace the rotary switch under the steering wheel.
Reconnect the rotary switch under the steering wheel, disconnect the computer connector and fit the 50
track B50 adaptor
.
The XRBAG must be used to measure insulation appropriate to the type of fault on adaptor cable C .
If the value obtained is not correct, check the connections on the 50 track connector (tracks 10 and 11)
and replace the wiring if necessary
FAULT FINDING - INTERPRETATION OF FAULTS
WIRING
Air bags and seat belt pretensioners
SIDE
88
88-55