WIRING
Air bags and seat belt pretensioners
88
Refitting
To refit it, position the sensor using its lug and
mount it to the vehicle before reconnecting the
connector(tightening torque : 0.8 daN.m).
After connecting its connector, carry out a check
using the fault finding tool.
Unlock the computer if everything is correct,
otherwise see the"Fault Finding" section.
Connection
Track
Description
1
Sensor supply
2
Earth
3
Not used
OPERATION ON THE TRIGGERING LINES
In the event of a fault noted on one of these lines,
the component must be replaced and not repai-
red.
This safety device can not tolerate any conventio-
nal repair operation on the wiring or connectors.
The air bag and pretensioner triggering lines are
integrated in the passenger compartment wiring
harness. In order to make repairs easier, the re-
placement method consists of cutting the two ex-
tremities of the faulty wiring and making the
new wiring follow the same route along the pas-
senger compartment wiring harness.
IMPORTANT:
when refitting the new wiring, en-
sure that it is not subject to damage and that the
original cleanliness has been respected.
Special case : the connector with lugs
A series of vehicles are fitted with a red connector
with lugs(A) passenger air bag module side.
16008R
To disconnect it, carefully use a small screwdriver
as a lever , so as not to damage the lugs .
In the event of the lugs breaking, replace the
connector using the kit part number : 77 01 206
210
using the following method.
88-15