Remotec Z-Thermostat ZTS-100, Руководство пользователя

Страница: 20 / 32

Note 1: This icon is represent the ZTS-100 has been added into the Z-Wave
network. Please perform the Delete (Exclusion) before adding into the
new Z-Wave network.
Note 2: User can control the ZTS-100 through gateway or controller after adding
into the Z-Wave network.
ZTS-100 can be configured as either "
Frequently Listening Routing Slaves"
(FLiRS) or "
Always Listening"
node and it will distinguish the power source
(batteries or 24Vac) automatically and switch to appropriate mode during inclusion
stage.
FLiRS node type is targeted for battery operated applications and will enter sleep
mode frequently in order to conserve battery consumption that can provide flexibility
if there is out of 24Vac power line.
Always Listening node type is targeted for AC power operated applications and it
can act as a repeater, which will re-transmit the RF signal to ensure that the signal
is received by its intended destination by routing the signal around obstacle and
radio dead spots.
Application for out of 24Vac power line:
1. Install AAx4pcs batteries and power up the unit.
2. Execute the step of "Delete (Exclusion) ZTS-100 from Gateway / Controller Z-
Wave network".
3. Execute the step of "Add (Inclusion) ZTS-100 to Gateway / Controller Z-Wave
network".
4. ZTS-100 will be configured as FLiRS operation after step 3 (inclusion).
ZTS-100 will not response Z-Wave command very quickly as it will enter
sleep mode frequently in order to conserve battery consumption.
Application for 24Vac power line:
1. Connect 24Vac power and power up the unit, make sure AAx4pcs batteries has
been removed.
2. Execute the step of "Delete (Exclusion) ZTS-100 from Gateway / Controller Z-
Wave network".
3. Execute the step of "Add (Inclusion) ZTS-100 to Gateway / Controller Z-Wave
network".
4. ZTS-100 will be configured as Always Listening operation after step 3 (inclusion).
It can install AAx4pcs batteries for power backup purpose after step 4.
19