If there are obstacles, place the mounting arm as close to where it needs to be on the roller
section. Typically, mounting arms should be 6”-10” from each end of the roller section.
Roller sections can be moved around to better fit the implement.
!
Do not over tighten bolts on one side more than the other, this will leave unleveled mounting
arms and bending of plates. Tighten all fasteners properly and evenly. Improper tightening
of bolts may cause plates to deform, which will not be covered under warranty.
!
4. Place the proper roller frame around the matching roller section. Tighten one end of the frame
to the roller. Use the 1”-8 x 3 3/4” hex cap bolts with spacer bushings, large flat washers & lock
nuts. Next, determine if the thin flat washer (one provided for each roller section) will easily slide
in between the frame and the end of bearing.
Do not force if gap is narrower than thin flat wash
-
er!!!
Not all sections may need this flat washer. Proceed to tighten frame to roller section. Each
roller section should spin freely without bearings dragging or squeaking. Repeat this for each
roller section provided.
5. Attach a complete roller section to a pair of matching arms. Use the 1/2”-13 x 2” x 3 1/2” U-bolts
with lock washers and hex nuts. Repeat this for each section of roller.
Note:
Rollers sections need
a minimum of ¼” gap between the frames in the non-wing fold hinge areas. In the wing fold hinge
areas of your implement, it is recommended to have a wider gap of 2”-3” for more contoured
ground and wings that flex. Certain applications require smaller frame sizes to be bolted together.
Note:
(2) 1/2” x 1 1/4” bolts are used.
6. Center the base section(s) of the roller(s) and then tighten in desired place. Then move to each
wing. Torque all bolts to recommended torque settings. See chart o
n
.
1/4” Gap (Non-Hinge)
Bolted Frame (3 arm)
2”-3” Gap (Hinge Fold)
Manual # - MAN-SRH-DFC-004
6
Remlinger Mfg reserves the right to change pricing or specifications at anytime without notice or obligation
1-800-537-7370
