Decrease spring tension to allow easier movement of roller arm if height needs raised or
lowered. If spring tension is set too extreme, attempting to raise and lower arm height may
cause injury.
!
4. There are 2 ways to adjust the arm up and down,
Major
or
Minor
adjustments. The
Major
adjustment on field cultivators and chisel plows will vary from that of disks and disk rippers. The
minor adjustment is done by removing the ½” bolt and arm stop spacer, locating to a higher or
lower set of holes. Set each roller section down onto the spacer boards, insert arm stop spacer
and ½” bolt back into hole setting so that a gap is underneath the arm. Tighten down the ½”
bolt with roller still on the spacer boards. This will be repeated for each roller section.
Note:
A
combination of both major and minor adjustments may be needed to get ideal roller height setting.
•
Major
– Adjust the Roller Mounting Arm up or down on the rear plate of extension.
•
Minor
– Move the Arm stop in the Roller Mounting Arm in the proper position.
The roller arm assembly is factory assembled and will need some kind of adjustment. Set-
tings will vary depending the implement that the roller harrow is attaching to.
!
Major
Minor
Manual # - MAN-SRH-DFC-004
10
Remlinger Mfg reserves the right to change pricing or specifications at anytime without notice or obligation
1-800-537-7370
