5
Assembly
5.1 Room installation of the
Smart Control
NOTICE!
Only use the unit in dry areas and protect it
from electromagnetic radiation.
The Smart Control remote can be mounted to a
wall, e.g. in the living room.
To wall mount the Smart Control remote, proceed
as follows:
1.
Fasten the wall bracket directly to the wall
using screws and rawl plugs.
2.
Connect the bus connection (maximum 50
m) with shielded cable (4 x 0.5mm²).
3.
Plug the connectors into the sockets on the
Smart Control.
+12V = Yellow / B = Green /
A = Brown / GND = White
4.
Slide the Smart Control into the wall bracket.
1
92
50.75
60
Ø 57
7
122.5
73
10.85
2
Fig. 36: Layout and dimensions of the back plate of
the wall bracket
1: Wall bracket / back plate
2: Cable feedthrough for wall installation
You have the option of connecting two Smart Con-
trol remotes at the same time. This assignment is
performed by allocating a Control Panel Address.
The Smart Control for the heat pump is "always"
given the address 1. Remote controls can then be
assigned under number two or three.
For a room influence the selected address for the
remote control must be assigned in the heating
cycle settings.
For installation and commissioning of the
REMKO Smart-Control remote control, follow
the corresponding instructions
39
