"3D house" animation
Once the Smart Control commissioning wizard has
been completed, you will see the home screen with
the 3D house. Pressing the left softkey starts the
animation. To return to the home screen with the
3D house, press "Cancel" (left softkey).
Overview
Next view
Start animation
Fig. 13: 3D house
To immediately display temperatures in the system,
you can press "Next view" (right softkey).
This is an overview of the key system data, repre-
sented using a 3D house.
2
Fig. 14: Explanation of View 1
1: Collector array
2: Heat pump outdoor unit
Fig. 15: Explanation of View 2
1: Conv. heat generator
2: Solar storage tank (primary)
3: Storage tank 2
4: Boiler (solid fuel)
5: Heater
Explanation of operating statuses:
Circuit is in operation
Hot water or heating is being heated by solar
energy
The heat pump is in operation
The heating is being provided by conventional
means
Explanation of other icons:
Manual operation (probe/actuator)
Fault present
Warning present
Current measured values, such as temperature or
output, are displayed. The lines refer to the indi-
vidual components.
The charging status of the storage tank is specified
in percent. 100 % means that the solar volume of
the storage tank is fully charged.
If a photovoltaic system is integrated, the following
values can be displayed.
Fig. 16: Explanation of View 3
1: Heat pump current
2: Domestic electricity
3: PV current
Depending on the level of equipment purchased
for the system, some components may not be dis-
played in the 3D house. It is also possible that
some components will be displayed which are not
present. However, for such components, no tem-
perature or operating statuses are shown.
Pressing the right softkey zooms in on the indi-
vidual components in the house and the current
parameters, such as storage tank and collector
temperature, are displayed
REMKO Smart-Control
12