System configuration
Pressing the
key next to
"SYSTEM CONFIGU-
RATION"
in the "SYSTEM" menu access the sub-
menu for configuring the system to which the room
thermostat is connected and which it controls. The
menu for this section includes the following items:
n
Boiler
n
Air heater
n
Hybrid
When the room temperature controller is
switched on for the first time and after any
memory loss, the default setting of the section
is "None". So, a new configuration must be
implemented.
After selecting the desired system, the
key
accesses the submenu for managing this system,
where the number of connected units (N. Slave)
can be set and room sensors of the room tempera-
ture controller can be managed. To set the number
of units connected to the remote control, use the
"N. SLAVE"
key to call up the selected sub-
menu.
Please note that the addresses on the pro-
cessors must be set from 1 to "n" without omit-
ting any number from the number sequence.
10:15
Ethernet
RS485
System
OK
10:15
Keine Anlage
Kessel
Lufterhitzer
Hybrid
OK
Kessel
10:15
Kessel
Fühlereinstellungen
OK
N. Slave
8
Mon 01 Jan
Mon 01 Jan
Mon 01 Jan
Rücksetzung auf Werkseinstellung
Systemkonfiguration
Systemkonfiguration
Systemkonfiguration
System
System configuration
Reset to factory setting
System configuration
System configuration
No system
Boiler
Hybrid
Air heater
Boiler
Boiler
Sensor settings
Fig. 13: System selection
After setting the system and its connected "slaves",
the
"SENSOR SETTINGS"
menu must be called
up with the
key in order to assign the room
sensors (connected to the room thermostat) to
each of the 4 available NTC inputs. The possibili-
ties are:
n
NTC sensor built into the ATR-Smart-Web/
ATR-Smart-Basic (optional) room sensor for
connection to terminals 9-10 of the ATR-Smart-
Web/ATR-Smart-Basic
n
(optional) room sensor for connection to termi-
nals 5-6 of the ATR-Smart-Web/ATR-Smart-
Basic
REMKO room temperature controller
16
