3
ENGLISH
GB
D
NL
F
E
I
DK
S
FIN
P
SK
CZ
PL
HU
N
RU
TR
RO
GR
SL
AE
HR/ SRB
GB
STEP 5 – The finishing touches – PICTURE 5
Use the clipper without an attachment comb for close trimming around the base and sides
of the neck. Use the ear comb guides to get a clean line around each ear. For the required
ear comb guide, angle the clipper and lightly stroke around each ear to the back of the
neck.
To produce a clean straight line at the sideburns, reverse the hair clipper. Place the
reversed clipper at right angles to the head, tips of the blades lightly touching the skin and
then work downwards.
TAPER LEVER (DIAGRAM 6)
This product has a taper lever located at the left side of the clipper near the blades. Adjust
the lever to change the closeness of the cut gradually and also to improve the effectiveness of
the comb attachments. The taper lever also extends the life of the blades because a different
cutting edge is used in each setting.
CARE FOR YOUR HAIRCLIPPER
Your clipper is fitted with high quality titanium blades that are permanently lubricated. To
ensure long lasting performance of your clipper, clean the blades and unit regularly. Always
keep the protective cap on the clipper blade.
AFTER EACH USE
Ensure the clipper is switched off and disconnected from the mains.
Brush the accumulated hair from the blades. Do not submerge the clipper in water.
To clean the unit, wipe with a damp cloth and dry immediately.
To reattach, line up the locating tab and then push blade set back onto main unit.
Note: Ensure that the clipper is turned off when cleaning.
EVERY SIX MONTHS
At regular intervals the Blade Set should be removed and cleaned.
Remove the 2 screws retaining the fixed blade with a screwdriver. Do not remove blade set.
Brush out hairs from between the blades with soft cleaning brush. Do not remove the
lubricating grease from the blades. Do not remove the small moving blade.
Before fully tightening the 2 screws, adjust the taper lever to the lower position and align
the blades so that their cutting edges are parallel to one another. Tighten the 2 screws.
Note that if the blades are not correctly aligned then cutting efficiency will be impaired.
CAUTION:
Do not use liquid cleaners on the blades or harsh or corrosive chemicals on the blade
casing. Always use a soft brush to remove the accumulated hairs.
Always store this appliance in a moisture-free area.
Do not wrap the cord around the appliance.
GB
100591_REM_IFU_HC5030_ INT_ 21L.indd GB3
100591_REM_IFU_HC5030_ INT_ 21L.indd GB3
11.08.10 21:29
11.08.10 21:29