5
•
Do not twist or kink the cable, or wrap it round the appliance.
•
This appliance is not intended for commercial or salon use.
PARTS
1. On/off switch
2. Adjustable zoom wheel
3. Length position indicator
4. Charging indicator
5. Stubble comb (1-5mm)
6. Short adjustable comb (1.5-18mm)
7. XL adjustable comb (20-35mm)
8. Pop-up trimmer
Not shown:
9. Beard towel
10. Beard bib
11. Scissors
12. Beard brush
13. Adaptor
14. Travel pouch
15. EDGEStyler
CHARGING
Before using your trimmer for the first time, charge for 16 hours.
1. Ensure the product is switched off.
2. Connect the charging adaptor to the product and then to the mains.
3. The charging indicator will illuminate. The charging indicator will remain
illuminated after the battery is fully charged.
•
Your trimmer cannot be overcharged. However, if it is not going to be used for an
extended period of time (2-3 months), unplug it from the mains and store.
•
To preserve the life of your batteries, let them run out every 6 months then recharge
for 16 hours.
•
On a full charge, your beard trimmer will run for up to 90 minutes of cordless usage.
CORDED
•
Connect the appliance to the mains and turn on.
•
We recommend you let the product charge for a few minutes before using corded.
CAUTION: Extended mains only use will result in the reduction of the battery life.
INSTRUCTIONS FOR USE
•
Cordless use – when the product is switched on and fully charged it can be used in
cordless mode for up to 90 minutes.
•
Switch the product on by sliding up the on/off switch.
•
Always comb your beard or moustache with a fine comb before you start trimming.
•
If you wish to trim your beard hair between 1.5-18 mm– attach the short length
adjustable comb.
•
For maintaining and trimming longer beard length between 20-35 mmattach the
XL adjustable comb.
Содержание Crafter Beard MB4051
Страница 2: ...2 e f g i j k l m h A h B h C ...
Страница 3: ...3 h E F H J G h D ...
