ENG
Non-contact three-stage self-cleaning mode
Clean water tank
is full
Dirty water tank is
empty
Do a self-cleaning after every cleaning
1. Before starting the self-cleaning mode, make sure that the clean water tank is full and the dirty water
tank is empty.
2. Place the applaince on the station. Make sure it is connected to the mains.
3. To start the three-stage self-cleaning, press the button located on the appliance body. Self-cleaning
process takes 60 seconds
4. After completing self-cleaning, remove the roller brush from the main nozzle and place it on the
special stand located on the station.
5. Use the supplied roller brush to remove reeled hair and wool from the brush.
6. Follow all the steps for cleaning the dirty water tank. To dry the HEPA filter, place it on a special
stand located at the station. It takes 24 hours for the HEPA filter to dry completely.
1
2
3
4
SPECIFICATIONS
Power
190 W
Operating voltage
22,2 VDC
Voltage
100-240 V ~ 50/60 Hz 0.8 A
Adapter output
27 VDC
Noise level
75 dBA
Battery capacity
5 000 mAh
Charging time
6 hours
Battery life
Eco mode — 45 min
Turbo mode — 40 min
Suction power:
Eco mode
Turbo mode
8 000 Pa
12 000 Pа
Brush revolutions
2 200-2 500 rpm
Cleaning water tank
0,6 l
Dirty water tank
0,55 l
Product dimensions
1150×270×250 mm
Appliance weight
3,9 kg
Guarantee
Country of origin of the brand
2 years
Germany
TROUBLESHOOTING
Problems
Possible reasons
Solutions
The vacuum cleaner
does not charge
• Charging voltage is not
supplied to the appliance
• Insert the charging connector
into the charging socket as far as
it will go. Make sure the charging
device is fully inserted into the
wall outlet.
Control buttons do not
work
• The battery is discharged
• There is no contact
between the handle and the
body of the device
• Check the battery power and
charge it fully
• Reinstall the handle
The vacuum cleaner
does not work
• The dirty water tank is full.
• Dirty water tank is not
installed.
• Roller brush is blocked
• Clean the dirty water tank
• Install the dirty water tank
correctly
• Clean the roller brush from
foreign objects and dirt
The indicator for the
presence of clean
water in the tank does
not work correctly
• It is not calibrated
• Remove the clean water tank,
then start the self-cleaning mode.
Then hold down the On/Off button
and the Eco/Max button at the
same time for 5 seconds, until the
display blinks twice. Release the
buttons and check if the faul has
been eliminated.
Low suction power
• The HEPA filter is dirty
• The HEPA filter is not dry
• Check and clean the HEPA filter
• Dry the HEPA-filter thoroughly
The clean water tank is
leaking
• The clean water tank is not
installed correctly
• The tank cover is not
properly tightened
• Install the water tank correctly
• Screw the cover back on tightly
When spraying, no
water is supplied
• The clean water tank is
empty
• The clean water tank is not
installed correctly
• Fill the clean water tank
• Install the water tank correctly
Voice assistant does
not work
• The voice assistant is
turned off
• To turn on/off the voice
assistant function, press the
button located on the back of the
vacuum cleaner body
The vacuum cleaner
does not operate in
self-cleaning mode
• The dirty water tank is full
• The clean water tank is
empty
• Clean the dirty water tank.
• Fill the clean water tank
