REMEHA Selecta, Техническая информация

Страница: 40 / 73

Remeha Selecta
40
9.2 Meaning of the various modes
9.2.1 General
After turning on the electric power to the boiler, or after pressing the ‘reset’- key, the
display defaults to the temperature mode. By pressing the ‘prog.’- key it is possible to
scroll through the display options, each key press moves to the next mode.
5 modes are available:
1. Temperature mode - Display shows number only no red dot (Default)
2. Programming mode - Display shows a number with a red dot illuminated
3. Service mode - Display shows a number with a red dot flashing
4. ‘forced High’ mode - Display shows
h
5. ‘forced Low’ mode - Display shows
l
Changes to the programming mode can be carried out via the boiler control panel, see
Par. 9.2.3.
Changes to the settings at service level should only be carried out by a qualified Engi-
neer using a PC or service tool,
see Par. 9.3.
Note: The settings at works level are intended exclusively for Broag personnel and will
therefore not be described.
9.2.2 Temperature mode
The temperature mode shows 1 digit per 10°C of boiler water temperature. For exam-
ple, a
6
on the display indicates a temperature of 60°C ± 5°C. In temperature mode
the red dot does not illuminate or flash.
9.2.3 Programming mode
The programming mode is separated in six groups (I till VI), with settings for pre-heat
levels, DHW, CH and pump. In each group only one option can be active. A dot is
flashing with the activated setting.
Note: Changes to the factory default settings effect the boiler operation and should
only be carried out after reading and understanding the following instructions.
To activate an option within a group:
In the temperature mode briefly press the ‘prog’- key once, the letter
P
appears on
the display. Press the ‘prog’- key for more than 1 sec and the letter ‘
P
’ will flash twice
confirming entry into the programming mode. Press the key again and
1
will appear
in the display with a static red dot, to activate this option press and hold the ‘prog’-
key. Each subsequent press of this key will display the numbers and letters of the rel-
evant parameters displayed in sequence (options
1
to
F
), see Table 06.