REL Acoustics G1 Mk II, Руководство по эксплуатации

Страница: 27 / 31

25
Theatre Applications
For Dolby Digital AC3 or other 5.1 theatre systems, once the standard set-up for two-channel outlined
above is complete, the LFE output from the processor or receiver should be connected to the .1/LFE INPUT
and appropriate volume adjustments made using the .1/LFE level control. For this configuration, you must
set the processor to the “large” or “full range” setting for the left and right speakers in order for the REL to
receive the bass signal via the high-level cable. In this configuration, the REL provides support for both the
left and right speakers for two-channel listening, and support for the LFE when movies are playing. Most
processors will allow you to defeat the subwoofer output when listening in the two-channel mode. The
effect of this set-up is one of greatly increased dynamics in the mid-bass range, no bass bloat, and a greater
degree of space and timing from the special audio effects. For an even greater sense of space and impact, a
second REL connected in parallel to the centre channel will prove to be a dramatic improvement as well. And
if that is not enough, a rear REL, both to support the rear channel speakers as well as to evenly distribute
LFE through the room, truly completes the full-range sonic picture for state-of-the-art film reproduction.
Running In
Care taken during run in will be rewarded by many years of pleasurable use. Both the electronics and the
drive unit will benefit from an initial period of carefully controlled use. Possible damage may be sustained
by running in the unit at too high a volume setting over an extended period. On the other hand, by taking a
little care over this initial period, about 24 hours of actual use, a longer life with a higher potential eventual
performance is assured.
Care and Polishing
The cabinets are best maintained by using an automobile polish made by reputable manufacturers. Our
favorites are those made by Meguiars and Mother’s. If objects are to be placed upon the top, it is advisable
to use a small mat to protect the surface and to avoid the risk of rattles.