Pg. 30
Doc ID: 191-6309001A
Doc Rev: 101619
5. Push the ¼ turn pin in far enough to clear the base, then
turn 90° and release the pin. The pin should sit almost
flush with the EXP base.
6. Flip the EXP friction disk over, and repeat on the other
side depending on engagement preference.
7. If you need to disassemble the EXP disk, you can watch
the video on our website under Tech Tips at
www.rekluse.com/support/videos/atv-mc-support-videos.
If you disassemble the EXP, the Teflon pads may fall
out or be stuck to the ramp surfaces of the EXP bases.
Take care to ensure all pads are correctly placed into
wedge pockets using gentle pressure to avoid damage
to the pad surfaces before reassembling the EXP.
Properly seated pads will be secured in place once the
EXP is reassembled. Operating the clutch without the
pads in place will cause part damage or failure.
