Pg. 32
Doc ID: 191-6309001A
Doc Rev: 101619
·
Repeat the break-in procedure anytime you replace the
frictions disks. Always soak friction disks in oil for at least
5 minutes before installing.
·
Replace the drive plates if they show signs of excessive
heat.
Disk inspection examples
When inspecting the clutch pack, the following pictures can
be used as a reference.
These are best viewed in color by
viewing this install document on
www.rekluse.com/support.
Drive Plates
–
If the clutch pack is getting high amounts of
heat, purple, blue, or black color can be seen on the drive
plate teeth. See pictures below. Not all drive plates look the
same and may look different than pictured.
Normal Heat
High Heat
Excessive Heat
(Blue)
(Black)
Friction Disks
–
Due to the dark color of the friction
material, the friction disks will appear almost black as soon
as they are put in oil. During inspection, look for glazing of
the friction material. Glazing will appear shiny and feel like
glass, even after oil is cleaned from the friction disk. Not all
friction disks look the same and may look different than
pictured.
