S-AGR08gb08
05/15 - 3
Page 10 of 15
8 Maintenance
8.4.1 Possible sources of error for the reassembly
Mount two gaskets (6) with air distributing ring
(7).
Essential to maintain correct position and
seat!
Insert the respective smaller diameter of
the gaskets into the air distribution ring.
Here the lower gasket is slipped!
A visual check is necessary!
Grease nozzle (4) and tighten with 30 Nm.
Pay particular attention to the pretension of
the gaskets (6). Place the paint nozzle manu
-
ally. Then tighten with a torque wrench to 30
Nm.
Use always a nut or socket wrench to tighten,
otherwise the nozzle can be deformed.
Under no circumstances use a wrench!
Attention: Ensure correct fit!
Place retaining ring and tighten
by hand.
Check annular gap between the paint nozzle
(4) and air cap (3) visually on round consistent
measure.
As illustrated on the left, it may not look like!
Check proper seating of the air cap visually!