Reiner jetStamp 1025, Краткая инструкция

Страница: 11 / 20

10
jetStamp 1025
GB
pressure cartridge
21
.
f
Close flap for battery and print cartridge
6
.
f
Install a new seal
9
into the device, holding the retaining clip of the seal in place
10
.
f
Insert seal tip
11
into the notch.
f
Press the seal
9
slightly down until it snaps into place in the holder.
f
Press function key for print cartridge
5
. Print carriage
7
returns to the basic position.
The change position can also be controlled via the display.
1.2. Install PCset graphic Software
Installation is only possible with administrator rights on the computer.
f
Insert the USB stick with PCset graphic into the PC .
f
If the installation programme does not start up automatically, start the file “
setup.exe
”.
f
Observe the installation programme instructions.
1.3. Firmware update
The most up to date firmware for the
jetStamp 1025
can be downloaded from the
REINER website (www.reiner.de).
1.4. Recognising and Removing Interferences
For more information, see the online help of the PCset graphic software, or the enclosed USB.
Contact
Ernst Reiner GmbH & Co. KG
Baumannstr. 16
78120 Furtwangen / Germany
Phone: +49 7723 657-0
Email: reiner@reiner.de
www.reiner.de
© 2019 Ernst Reiner GmbH & Co. KG
All rights reserved. Translation, reprint and other reproduction of these operating
instructions, even in parts and no matter the form, shall require our express written consent.
We reserve the right to make content changes to these operating instructions without notice.