Reichert XCEL 455, Руководство пользователя

Страница: 10 / 28

10
15140-101 Rev. C
Setup
(continued)
Unpacking and Installation
(continued)
10. Using the 4mm Hex Wrench, adjust the Patient
Handles by loosening the Screws that are
securing them to the Chinrest Posts. Slide
the Patient Handles up or down to the desired
height, and secure them in place by tightening
the Allen Cap Screws. Refer to Figure SU-7.
11. Attach the Fixation Light Wire from the Chin Rest
Assembly into the connector on the back of the
Power Supply Assembly. Refer to Figure SU-8.
12. Open the box with the Illumination Assembly and
remove it. Refer to Figure SU-9.
13. Using the 5mm Hex Wrench, remove the Screw on
the bottom of the Illumination Assembly and Arm.
Note: The Illumination Assembly and Arm are con-
nected as one piece.
14. Mount the Illumination Assembly and Arm onto the
Base Assembly and secure it with the Screw using
the 5mm Hex Wrench. Refer to Figure SU-10.
Note: There is a Notch in the Base Assembly, and
a Slot in the Illumination Assembly. Align the
Illumination Assembly and Arm so the Notch
goes into the Slot. If the Notch is not aligned
properly, the Slit Lamp will not sit flush, and
won’t be aligned properly. Refer to Figure
SU-11.
-continued-
Figure SU-10 Screw
Screw
Base
Assembly
Arm
Illumination
Assembly
Figure SU-7 Adjusting Patient Handle Height
Screws
Move
Handles Up
or Down
Figure SU-8 Connections
Fixation
Light Wire
Base
Lamp
Wire
Figure SU-9 Illumination Assembly
Figure SU-11 Line Up Notch
Illumination
Assembly
and
Arm
Base
Slot
Notch