REHM FOCUS.ARC P 250, Руководство по эксплуатации

Страница: 55 / 82

Commissioning
55
10 Commissioning
10.1 Safety instructions
Carefully read the operating instructions, in particular the
➔
Section 2 Safety,
before commissioning and before beginning work with this welding current
source.
Warning!
REHM welding equipment should be operated only by persons who are
trained and instructed in the use, maintenance and the safety regulations
concerning welding systems.
When welding always wear protective clothing and take care to avoid other
persons who may be in the vicinity being endangered by the UV radiation
emitted by the welding arc.
10.2 Working under elevated electrical risk in
accordance with the regulations from IEC 974,
EN 60 974-1, TRBS 2131 and BGR 500 Section
2.26 (previously VGB 15) (S)
The REHM - FOCUS.ARC P - gas welding equipment complies with the above-
mentioned regulations. It must be noted that for work under increased electrical
hazard, the welding current source must not be placed in this area. Regulations
EN 974-1, TRBS 2131 and BGR 500 Section 2.26 (previously VGB 15) must be
observed.
10.3 Positioning the welding unit
Place the REHM welding system so that the welder has sufficient space in front
of the unit to adjust and operate the controls.
Transport the unit only under compliance with the applicable accident prevention
regulations.
ATTENTION: The attachment of the FOCUS.ARC P systems for hanging
transport, e.g. on ropes or chains, is only permitted with the use of the
crane eyelets. Fastening to the handles or other parts of the system is not
permitted.
Danger! Electrical voltage!
Do not use the welding unit in the open in the rain!