REHM FOCUS.ARC P 250, Руководство по эксплуатации

Страница: 11 / 82

Safety information
11
2.3 Notes and requirements
The system was developed and designed by the generally accepted rules of
technology.
Nevertheless, residual dangers to the life and limb of the operator or the risk of
damage to the system or other property may still arise in the use of the system.
Safety equipment must never be dismantled or put out of operation as this will
result in dangerous hazards and the intended use of the system is no longer
guaranteed. The dismantling of safety devices for equipping, repairing and
maintenance is described in detail. The safety devices must be refitted
immediately on completion of such work.
When using external aids and agents (for example, solvents for cleaning) the
user of the system is responsible for ensuring the safety of the unit.
All safety instructions and warnings and the nameplate on / near the system must
be kept visible and legible.
The occupational safety and health regulations serve as safety references. They
must be observed.
In addition to the safety instructions listed in this section, the safety instructions
contained in the current text must also be observed.
Beside the advice given in these operating instructions, the general safety and
accident prevention regulations (in Germany, among others UVV BGV A3, TRBS
2131 and BGR 500 Chapter 2:26 (previously VGB 15): "Welding, cutting and
allied processes" and particularly the conditions for arc welding and cutting
contained therein or the corresponding national regulations) must be observed.
Also observe the safety information signs on the factory floor of the operator.
REHM welding machines are, except when this is expressly stated in writing by
REHM, only for sale to commercial / industrial users and are only intended to be
used by commercial / industrial users.
The FOCUS.ARC P MIG/MAG gas welding equipment is designed in accordance
with EN 60974-1 Arc welding equipment - welding power sources for overvoltage
category III and pollution degree 3 and in accordance with EN 60974-10 Arc
welding equipment - electromagnetic compatibility (EMC) and may only be used
on mains supply systems which have a three-phase four-wire system with
earthed neutral conductor.
FOCUS.ARC P inert gas welding systems may only be used
•
as intended
•
in an absolutely perfect condition
Hazards of non-
compliance
Safety information
Applications