REHM BARRACUDA RTC 100, Руководство по эксплуатации

Страница: 6 / 55

Introduction
6
except where expressly stated otherwise in writing by REHM, REHM plasma
cutting equipment is only intended for sale to commercial or industrial users and
only for use by such users.
BARRACUDA plasma cutting equipment should only be used
a) for the purpose intended and
b) in a safe condition
REHM plasma cutting equipment may only be operated by personnel trained and
instructed in the use and maintenance of plasma cutting equipment. Only
qualified, authorised and trained staff may work on and with the equipment.
These operating instructions contain important information on the safe, correct
and economic operation of the equipment. A copy of the instructions must be kept
at all times in an appropriate place where the equipment is being used.. Please
make sure that you read the information summarised in this operating manual
before using the equipment. You will gain important information regarding the use
of the equipment which will enable you to use the technical advantages of your
REHM equipment to the full. In addition, you will find details regarding
maintenance and upkeep, as well as operating and functional safety.
These operating instructions are no substitute for training given by REHM service
staff.
The documentation relating to any optional accessories installed must also be
noted.
No alterations to the equipment are permitted, nor are the attachment or
installation of any additional equipment. Such actions will result in cancellation of
any right to make warranty and liability claims.
Warranty rights will also be forfeited if any work is performed on the unit by third
parties or if any safety devices are deactivated.
Areas of
application
Qualifications of
operating
personnel
Purpose of the
document
Alterations to the
equipment