20
The order of refilling
Consumables: MT, ethyl alcohol.
To fill up the operating reserve of MT, do the following: take MT from the SPRK, cut it into strips
of necessary length and enclose them into the cartridge intended for storing MT (Fig. 6, pos. 1).
To cut metal MT, use the cutter from the SPRK and do the following:
z
Set the cutter lever (Figure 5, pos. 1) in the upper position, letting the tape freely pass
through the slot as shown in Figure 5a.
z
Push the MT strip in the area marked as 6 (see Figure 5a) to move the MT strip
(Figure 5, pos. 3) through the slot beyond the edge of the blade (Figure 5, pos. 2).
z
Take the MT by its edge (Figure 5, pos. 3) and pull it out for a required length, relative
to the blade edge (Figure 5, pos. 2). The cutter body (Figure 5, pos. 4) can be used
for measuring the approximate length of the MT strip. A full loop of the tape around
the body is equal to the operating MT strip length — 250 mm.
z
Lower the cutter lever (Figure 5, pos. 1) and slightly press it down to fix the tape as
shown in Figure 5b.
Figure 5
1 — lever,
2 — blade,
3 — MT,
6
5
4
1
2
3
а)
MT extraction from the bunker for cutting
b)
Cutting MT with the cutter
4 — body,
5 — bunker with MT reserve,
6 — area for pushing MT.
Содержание 7517A
Страница 2: ......
