Regency Plateau™ Series Outdoor Gas Fireplace
19
INSTALLATION
End Caps
Before installation,stainless steel must be handled and cleaned as per instructions noted below:
Stainless Steel Table Top
• Stainless table top must be inspected for scratches and dimples prior to installation. All claims to be recorded at this time.
Claims for damage after installation will not receive consideration.
•
To protect the fi nish during installation and handling
- cotton gloves
MUST
be worn at all times while handling the panels (even when
removing protective coating).
•Stainless table top will discolor a little during normal operation.
This is normal and should not be considered a defect.
*
All hand and fi nger marks
MUST
be cleaned off with a soft cloth and a stainless steel cleaner. Most stainless steel cleaners leave a fi lm/
residue on the surface of the panels. Use an ammonia based cleaner (ie. glass cleaner) to remove this fi lm before applying heat to the unit.
Failure to do this will result in burn stains on table top which you will be unable to remove.
Not protected by product warranty.
*
All hand and fi nger marks
MUST
be cleaned off with a soft cloth and a stainless steel cleaner. Most stainless steel cleaners leave a fi lm/
residue on the surface of the panels. Use an ammonia based cleaner (ie. glass cleaner) to remove this fi lm before applying heat to the unit.
Failure to do this will result in burn stain on panels which you will be unable to remove.
This is not a warranty item.
TABLE TOP INSTALLATION - COFFEE TABLE UNIT
NOTE
: These instructions apply to both the stainless steel and sunset
bronze table tops.
1)
Place table top over completed unit.
2)
Place end caps over pilot and opposite end to complete installation.
3)
To remove - reverse steps.
Final Install
