36
|
Regency® P33E-10 Zero Clearance Direct Vent Gas Fireplace
|
36
installation
Diagram 1
Diagram 3
STANDARD FLUSH DOOR
The standard flush door
comes with a black
frame. To install the frame, simply hook the top
door flange onto the top of the unit and swing
the door towards the unit, diagram 1. Be careful
that the glass gasket does not roll up; there must
be a gap between the gasket and the door lip to
ensure that the door sits securely on the unit.
See Diagram 2.
Diagram 2
5th Grate Tab
6) Place the bottom left front edge of Log 251
against the left edge of the burner tray and
rest the log on the cutout on Log 253.
7) Position Log 252 across the cutouts in Logs
254 and 253. The notch in the bottom right
end fitting against the 5th grate tab.
8) Pull off ember size pieces of rock wool and
gently place them on the front of the burner
tray in the places shown in the photo below.
Do not compress the rock wool, leave it
loose.
Separate platinum embers and place them
on the front of the burner on and around the
rock wool.
Place rock wool in these 2 locations
on the burner tray.
251
252
250
254
253
250
254
253
251
253
250
254
253
254
252
Cutout
9) Test fire to ensure proper light off (make
sure flame flows smoothly from one end of
burner to the other). If there is any flame
hesitation, check that area for any blockage
of the burner ports.
Use the hook to pull the spring out until you can
put the hook into the slot on the bottom door
bracket. Repeat for 2nd spring. See diagram 3.
To remove the flush door, reverse the above
steps.
