12
Regency I43-1 ULTIMATE Gas Inbuilt Fireplace
Trim Clips
tighten top
screw only
Rear View
INSTALLATION
Tabs
Screws
Right
Side
Top
Hinged
Louvers
FACEPLATE & TRIM INSTALLATION
Hint: Before doing the faceplace installation, leave the
inbuilt out approximately 4" so wires may be hooked
up easier.
1)
Lay the faceplate panels fl at, face down on something soft
so they don't scratch.
2)
Take the top faceplate and align the holes in it with the
holes in the side panels.
Attach, using the screws
provided. See diagram
1.
Note: The holes
in the top
panel are
s l i g h t l y
larger
than the holes in
the side panel to
facilitate
easier installation.
Hint: Don't tighten the screws
down completely at this point, fi rst
do a trial fi t to the unit. Make any
necessary a djustments and when
it fi ts properly then tighten down
the screws.
3)
Using the trim clips provided,
join the left side gold trim (the one with the ON/OFF switch and FAN switch) to the top gold trim. See diagram 2. Repeat
this step for right side.
Diagram 4
Diagram 1
Diagram 2
4)
Place the trim on the assembled faceplate panels, aligning
the wires from the switches with the notch in the left side
faceplate panel.
5)
FAN switch wires:
Hookup the 3 Fan Switch wires to the
fan switch on the left side trim.
6)
Burner ON/OFF wires:
Hookup the 2 Burner ON/OFF wires
to the Burner switch on the left side trim. Diagram 3.
7)
The power cord should be run behind the faceplate panel.
8)
Push the logo plate into the two holes in the bottom left
corner of the left side faceplate panel.
Diagram 5
Diagram 3
9)
Secure the gold trim to the faceplate by drilling a
1/8" hole through into the faceplate side
fl ange, using the hole in the trim as a
guide. Now fasten with the two brass
plated screws provided.
10)
Lift the assem-
bled faceplate
up and over the
top of the inbuilt
and then lower
it down so the
faceplate tabs
are in line with
the faceplate
brackets. See
WARNING: The 3 wires are to the Fan and the 2 wires
are to the Burner ON/OFF switch. DO NOT connect
to the wrong switch.
diagram 4. Once everything is properly lined up you
can tighten the 4 screws on the faceplate brackets. See
diagram 5.
Note: If you are making custom faceplates, you must
use the faceplate louvres. Failure to do so will void the
certifi cation on your unit. The faceplate louvres can be
purchased separately, part #: 610-909.
