Regency Fireplace Products Liberty LRI4E-LP, Инструкция для владельца и по установке

Страница: 42 / 64

42 |
LRI4E / HRI4E Direct Vent Gas Insert
|
42
operating instructions
OPTIONAL HEARTH TRIM
INSTALLATION -
VIGNETTE FACEPLATE WITHOUT SPACER
Customizing the Hearth Trim
The Hearth Trim can be adjusted to custom it an installation by
pulling apart the top piece from the bottom piece. Minimum height
of the hearth trim is 2” and can be adjusted up to maximum 6”.
1. Discard the spacer brackets, as these are not required when installing
the unit without spacer.
2. Cut the top of the bottom piece of the hearth trim to the appropriate
height using a metal cutting blade.
NOTE: The tab bends at the back of the top piece of the hearth trim
should be used as the measuring point to the hearth to measure
the height required.
4. Line up the hearth trim with base of the unit and secure it with 3 screws
as shown below.
3. Reattach the top piece of the hearth trim to the cut bottom piece by
itting in place.
(152 mm)
(51 mm)