Regency Fireplace Products Contura Ri50, Инструкция для владельца и по установке

Страница: 16 / 84

When a metal prefabricated chimney is used, the manufacturer's
installation instructions must be followed. You must also purchase
and install the ceiling support package or wall pass-through and
"T" section package, firestops (where needed), insulation shield, roof flashing, chimney cap, etc. Maintain proper clearance to the
structure as recommended by the manufacturer. The chimney
must be the required height above the roof or other obstructions
for safety and proper draft operation.
Masonry Chimney
Ensure that a masonry chimney meets
the minimum standards of the National
Fire Protection Association (NFPA) by
having it inspected by a professional.
Make sure there are no cracks, loose
mortar or other signs of deterioration
and blockage. Have the chimney cleaned
before the fireplace is installed and
operated. When connecting the fireplace
through a combustible wall to a masonry
chimney, special methods are needed.
Masonry Fireplace
There are listed kits available to connect
a fireplace to a masonry fireplace. The
kit is an adapter that is installed at the
location of the fireplace damper. The
existing damper may have to be removed
to allow installation.
This unit is designed to use either a
5.5" (140mm) or 6" (152mm) flue liner
only within the confines of the masonry
chimney as shown.
Flashing and Cap
FireClay liner
Listed Stainless Steel Flex Liner
Stainless Tee with Cleanout
Stainless Connector Pipe
Damper Plate is Removed or
Fastened in Open Position
Use Damper Adapter or
Seal With Sheetmetal and Sealant
M
in. 56
¼" t
o c
en
ter
line
Chimney cleaning access
Fireclay flue liner with airspace
Concrete Cap
Flashing
Eave
Airtight Cleanout Door
1 Inch Clearance
Rafter
Ceiling Joist
M
in. 56
¼" t
o c
en
ter
line
Thimble-12 Inch of Brick
Chimney cleaning access
Attach adaptor and Double Wall
Connector using two screws.
Follow Manufacturer Instructions.
Combustible Wall
I Inch Clearance with Fire Stop
Floor Protector
When referencing installation or
connection to masonry fireplaces or
chimneys, the masonry construction
must or shall be code complying.
Only listed double wall connector to
be used.
Only listed double wall connector to
be used.
When referencing installation or
connection to masonry fireplaces or
chimneys, the masonry construction
must or shall be code complying.
Factory Built Chimney
Be aware that local Codes and Regulations may override some clearances/
installations listed in this manual. Check with your local inspector.
Be aware that local Codes and Regulations may override some clearances/
installations listed in this manual. Check with your local inspector.
EN
16
installation