Regency Fireplace Products City ACV60E, Инструкция для владельца и по установке

Страница: 78 / 96

78
|
City Series ACV60E
installation
Split Wood Log Set Installation
920-315 12.23.20
Read the instructions below carefully and refer to the images. If the logs are broken do not use the unit until they are replaced.
Broken logs can interfere with pilot operation.
Improper positioning of the logs may create carbon build-up and alter the unit's performance, which is not covered under warranty.
*Paint is included if touch ups are required.
1 Rear Center Log
2 Rear Left Log
3 Rear Right Log
4 Left Front Log
5 Front Log (left of center)
6 Front Centre Log Piece
7 Front Right Log (right of center)
8 Left Cross Log (2nd left from center)
9 Left Cross Log (left of center)
10 Right Cross Log (right of center)
11 Right Cross Log (2nd right from center)
12 Left Cross Log (far left log)
13 Right end log
Log Guides (3)
0.9 kg Black Fireglass (purchased separately from log set)
Glowing Wool (supplied with unit)
19 mm Crushed black glass
(purchased separately from log set)
1. S hut off gas and electrical supply, allow unit to cool to room temperature.
2. Remove barrier glass (if already installed) and firebox glass (see
manual).
3. Carefully remove the logs from the packaging and unwrap them.
The logs are fragile, handle with care—never force into position.
4. Install black fireglass (0.9 kg) and glowing wool on the burner as
shown below.
Burner covered with Fireglass and glowing wool
5. Insert the log guides (3 pieces) into the slots at the back of the burner.
1
ACB60/ACV60E CITY SERIES
CITY SERIES 60 - SPLIT WOOD LOG INSTALLATION (AUSTRALIA)