Gate Assembly
Start with the main gate assemblies (A).
Loosen the hinge knob in the clockwise
direction. Doing this will let main gate
assemblies unfold.
Slide the two gate assemblies together. Place
the door frame u-bracket (F) over the lower
frame lining over the four (4) holes. Using the
allen wrench (D) tighten down the four (4) pan
head screws (B). Rotate the allen wrench in the
clockwise direction to tighten the screws.
Set the door frame assembly (G) into the gate.
Set the pin of the door into the receiver hole on
the bottom main frame assembly.
Place the upper door hinge pin (E) through the
hole in the main frame assembly and into the
door frame assembly.
Determine what side you wish to have the hinge
of the door on. Place the wall mounts on that end
of the gate against the wall. Using the wood
screws (C), screw into the wall. Turning the a
screwdriver in the clockwise direction will tighten
the screws. Repeat on both ends of the gate.
Tighten all the gate hinges by twising the hinge
knob counter clockwise direction.
NOTE:
Once the upper door hinge pin is
installed it will not be removed easily.
NOTE:
If your application does not require both
extension gates, refer to removing extension gate.
STEP 1
STEP 2
STEP 3
STEP 4
STEP 1
STEP 2
