-5
-
6. LCD monitor
When the unit is running, the LCD monitor will go dark if no buttons are pushed. Push any
button once to light monitor.
7. LCD display function
（
1
）
Show Power On when the machine has already connected but not started.
P o w e
r
o n
n
U n
i
t
O
（
2
）
Show UnitOn when the machine in working status(This display will disappear in 2
seconds and then the next screen will appear.)
Use to confirm a selection.
4. Select/OK Button
OK
These buttons are used for adjusting humidity or timer settings.
5. UP Botton Down Botton
Timer setting:
Timing for the start/Timing Shutdown/Cycle Timing
Temperature Scale Switch:
Degrees Celsius or Fahrenheit selection
Return:
Return to display the main page
NOTE: See Section 8 for more detailed programming instructions.
（
3
）
The LCD interface shows two lines of data. The first line displays the room
temperature and humidity. On the second line, Job T(working time) and Humidity Setpoint are
displayed on an alternating basis.
I
n
l
e
t
3 2 ℃
7 6 %
The contents of the second line alternateevery 10 sec.
REFINE-DEHUMIDIFIERS
-4
-
Humidity Setting:Adjust the humidity setpoint
※
Operating instructions
※
※
Control Panel Operation
OK
M
P
Menu
up button
Down Button
LCD Monitor
On/Off
Select/OK
Drain Pump
1. ON/Off Button
Press this button, and the machine will start running. Press this key again and the machine
will stop running. The display will show room humidity levels except while you’re pressing
another button. NOTE: When unit is turned off, the fan will run for 1 minute prior to shutting
off. In addition the condensate pump will pump for approximately 14 seconds to drain the
pump reservoir after unit is powered off.
2. Pump Button
P
For extended storage or movement of the machine, press the “Pump” bottom to
remove water from the integral pump’s reservoir.
3. Menu Button
M
Pressing the Menu (M) button, gives you the options to select between two different
control modes as well as adjust the temperature measurement units. Continue pressing the M
button until you get to your desired selection. Press the Select (OK) key to confirm that
selection and move to a submenu.
After you’ve completed your task select“R”thenpress the select (OK) button to
moveback to Previous Menu, or wait for 10 S for automatically returning to main screen.
Four selections are available:
REFINE-DEHUMIDIFIERS