REFINE-DEHUMIDIFIERS
-3
-
※
Unit Overview
※
※
Front View
Handle
Wheel
※
Rear View
Control panel
Front cover
Air iutlet
Power Cord Input
Hose and
Cord Rack
Drain Tube
Connection
Air Intake
Air Intake
Door Latch
Rear cover
-2
-
How Your Armored Dehumidifier Works
The Refine Armored Series Dehumidifier utilizes either its integral humidistat to monitor
the conditioned space or a manual on/off control to energize the compressor when needed.
Air is drawn across an evaporator coil. The evaporator coil is cooler than the dew point of the
air so water vapor will turn into liquid condensation. Air is then reheated through the
condenser coil and distributed back into the room.
Installation:
120 Volts AC may cause serious injury from electric shock.
WARNING!
1. Disconnect electrical power before servicing
2. Only plug unit into grounded electrical outlet
3. Do not use extension cord
4. Do not use plug adapter
Power Supply:
220V, 50 Hz AC Only 1 Phase
Outlet Requirement: 3-Prong, GFI
Circuit Protector: 15 Amp Time Delay Fuse or Circuit Breaker
Alternatively, you can manually control unit to operate independent of space conditions.
Place unit in desired location. The inlet of unit should be at least 8”from any obstructions.
If unit is transported in the horizontal position, allow it to sit in upright position for at least 30
minutes before operating.
It is recommended that the unit be removed from any location where corrosive or high
VOC content materials are applied.
WARNING!
REFINE-DEHUMIDIFIERS