Refco Startek, Руководство по эксплуатации

Страница: 5 / 28

English
4
paragraph 10, then inserting the leak detector probe into the blower
resistor block or condensate drain hold if no water is present, or into
the closest opening in the heating/ventilation/air conditioning case
to the evaporator, such as the heater duct or a vent duct. If the
detector alarms, a leak apparently has been found.
10. The accumulation time shall be 10 minutes.
11. Following any service to the refrigerant system of the vehicle, and
any other service which disturbs the refrigerant system, a leak test
of the repair and of the service ports of the refrigerant system shall
be done.
BATTERY INSTALLATION AND
REPLACEMENT

Turn the power off.

Remove the battery cover from the back of the instrument by
pressing down while simultaneously sliding the cover back. Be
careful not to lose the extra sensor stored in the battery
compartment.
 Insert 2 size ‘AA’ alkaline batteries.

Slide battery cover back into place.