Reely Pocket Drone FPV, Руководство по эксплуатации

Страница: 31 / 40

31
b) Controlling the quadcopter with the app icons
When you start the app, a number of icons are displayed with the camera image (see figure 16). In addition to the
camera control icons (see figure 14, position 2 - 4), the remote control icons are displayed when you select the cor -
responding icon in figure 16, position 6/8. The left-hand control icon (figure 16, position 12) controls the altitude and
rotation about the vertical axis (yaw). The right-hand control icon (figure 16, position 13) controls the pitch and roll.
Figure 16 shows the trim icons for "yaw" (position 14), "roll" (position 15) and "pitch" (position 16).
To trim a function, touch the left/right arrow (for "yaw") or top/bottom arrow (for pitch) until the quadcopter responds as
desired. Refer to section 12. b) for more information on how to trim the quadcopter.
To control the quadcopter with your smartphone and in-app controls, follow the steps below:
Switch the quadcopter on. The LEDs in the outrigger arms will start to flash and the quadcopter will emit a Wi-Fi signal.
Switch on your smartphone. Go to "Settings/Wi-Fi" and connect your smartphone to the "REELY-xxxx") network.
On your smartphone, launch the "REELY" app for the "Pocket Drone".
Select "CONNECT". The in-app control icons will be displayed (see figure 14) together with the video image from the
built-in camera.
Place the quadcopter in a suitable take-off position. Refer to the instructions in sections 11 and 12.
Select the icon in position 6, figure 14, and then select the icon in position 6, figure 14. The control pads will appear as
"points" together with all other icons that are needed to control the quadcopter (see figure 16).
The LEDs on the outrigger arm should now be constant. This indicates that the quadcopter is connected to the
smartphone app.
Select the icon in position 10, figure 16. The rotors will start and the model will take off and hover in front of you at a
height of approximately 1.5 m.
The two control icons (see figure 16, positions 12 and 13) function like the control pads on the remote control. Keep
your smartphone in your hands. Touch each "point" with your finger (for best results, use your thumb) and control the
quadcopter in the same way as you would with the remote control (see section 11 and 12).
To land the quadcopter, move the left-hand control icon (figure 16, position 12) backwards slightly. Alternatively, initiate
an automatic landing by selecting the icon in figure 16 (position 11).