Reely HCP80, Руководство по эксплуатации

Страница: 76 / 240

76
d) Connecting the Flight Batteries
Move the control stick for the pitch and tail functions (also see
figure 1, item 17) to the bottom position and switch on the
transmitter. Observe the correct position of the toggle switches
„Flight Mode“ and „Throttle hold“.
Then connect the plug of the helicopter connection cable (1)
that is protected against polarity reversal to the plug connector
of the flight battery (2). Observe that the connection cables do
not drag at the main pinion (3) and are not damaged.
Right behind the battery connection, the LED under the canopy
(see figure 20, item 6) of the helicopter lights up and the elect -
ronics in the model perform a reconciliation. If the LED flashes
slowly, the helicopter is not receiving a remote control signal.
After approx. 4 seconds, the swash plate (4) moves up and
down briefly twice to signal successful reconciliation of the
electronics and binding of the helicopter to the transmitter.
The swash plate should now be aligned perfectly horizontally
(see auxiliary line in the lower figure).
Now your model helicopter is ready to start.
If the swash plate is slightly tilted, use the trim or twist the linkage rods to adjust the swash plate precisely.
For further information on this, see the following chapters „Trimming the Model Helicopter“ and „Fine-Tuning
the Model Helicopter“.
Figure 10