Reed Instruments R6050SD, Инструкция по эксплуатации

Страница: 14 / 24

14
Enabling/Disabling the Beeper (bEEP)
Follow steps 1 and 2 when "bEEP" appears on the LCD.
1.
Press the and buttons to select between On (enabled) or
OFF (disabled).
2. Press the
ENTER
button to confirm selection and skip to
next parameter.
Note:
At any time, you can press the
ESC
button to exit the Setup mode
and resume normal operation.
Selecting Thermocouple Type (tYPE)
Follow steps 1 and 2 when "tYPE" appears on the LCD.
1. Press the and buttons to select between type K and J.
2. Press the
ENTER button to confirm selection and skip to
next parameter.
Note : At any time, you can press the ESC button to exit the Setup mode
and resume normal operation.
Selecting the Temperature Unit of Measure (t-CF)
Follow steps 1 and 2 when "t-CF" appears on the LCD.
1. Press the and buttons to select between °C and °F.
2. Press the
ENTER
button to confirm selection and skip to
next parameter.
Note : At any time, you can press the ESC button to exit the Setup mode
and resume normal operation.
Setting the Data Logging Sampling Rate (SP-t)
Follow steps 1 and 2 when "SP-t" appears on the LCD.
1. Press the and buttons to adjust the sampling rate between 0, 1,
2, 5, 10, 30, 60, 120, 300, 600, 1800, and 3600 seconds.
2. Press the
ENTER
button to confirm selection and skip to
next parameter.
Note : At any time, you can press the ESC button to exit the Setup mode
and resume normal operation.
continued...
REED Instruments
1-877-849-2127 | info@reedinstruments.com | www.reedinstruments.com