11
Simulating Transmitter Output (XMT)
1.
Insert one end of the test lead to the 'XMT' output jack of the calibrator
and connect the other end with the input terminal of the user's instrument
as shown in the following diagram:
2. The button-operation is the same as that as indicated in the
Current
Output
section.
Note:
•
Power supply range: 5 to 25V DC.
•
During an output operation, use a external 24V DC power supply in
order to prolong battery life.
Battery Replacement
When the
appears on the LCD, the batteries need to be replaced.
Follow the instructions below to properly replace the batteries.
1. Turn the power off the meter and remove any test leads that may be
attached to the meter.
2. Lift the tilt stand on the back of the unit to access the battery
compartment door, which can be removed using a Phillips
head screwdriver.
3. Replace the 2 x "AA" batteries in the lid of the battery compartment.
XMT
V
30V
MAX
MAX
30V
30V
MAX
+mA-
5--25VDC POWER
continued...
REED Instruments
1-877-849-2127 | [email protected] | www.reedinstruments.com
