6
High/Low Voltage Detection Modes
1.
When the detector is powered on the red indicator light on the panel
will light up indicating the default voltage detection range is set to
High (90 to 1000VAC).
2.
Press the power button once and the red indicator light will switch to
green indicating the detector is now in Low Voltage Mode
(24 to 1000VAC). In low voltage mode, the detector is more sensitive
to electrical interference/noise. Please only use low voltage mode
during weak electrical field environment.
Low Battery Indicator
When the battery voltage is lower than 2.4V, the detector will automatically
turn OFF.
Auto Power Off
The detector will auto power off when it is not used for 5 minutes.
Battery Replacement
1.
Hold the detector with one hand, use your thumb of the other hand
to press down on the battery compartment latch, and pull the end of
the detector.
2.
Pull out the end of the
detector along the direction
shown and replace
the batteries.
www.calcert.com
1.800.544.2843
0
5
10
15
20
25
30
