USER MANUAL
22
12.6
INFLATE THE BOARD:
12.6.1
Two stages of inflation
• The pressure in the FIRST STEP of the inflation to be able to introduce the chassis in the
holes:
0.5 PSI
(so that the board is formed semi-soft)
• The pressure in the SECOND STEP: recommended is
12 PSI
.
DO NOT USE a compressed air compressor:
it could damage or tear the board
•
During the first inflation, we recommend inflating the bike board in a room where the
temperature is around room temperature: the PVC will be more flexible and easier to assemble.
•
If the board has been stored in a cold room (less than 0°C / 32°F), place it in a warmer place
(20°C / 12°C) for 12 hours before unfolding.
•
Inflate the SUP with the supplied high-pressure pump. This pump is equipped with an adapter for
the valve.
12.6.2
Valve operation:
•
The inflation valve is on the back of the board; it must be closed to inflate the board.
•
Make sure the valve stem is up. If it is down, push it slightly until it rises to the waterproof position.
•
Lock the valve cap once inflation is complete. This will prevent any unintentional deflation and
will also prevent particles from being inserted into the interior.
12.6.3
Inflation process:
1. Make sure the valve tube is clean and in good condition and in a closed position.
2. Check that the hose is connected to the pump.
3. Attach the nozzle to the air pump to the valve on the board by turning it a quarter turn to
secure.
4. Inflate while pumping.
5. The gauge needle indicates a pressure starting at 4 psi. Therefore, inflate your bike deck for
several minutes before the gauge needle pops out.
CAUTION:
Using a non-approved compressor can seriously damage your board and void your
warranty.
12.6.4
Tips y precautions:
•
The board must be inflated with a hand pump for this product.
•
Do not use compressors to inflate your board that is not recommended by the manufacturer.
•
Always check pressure before using this product. Over time it will lose air, so check before use.
•
Before using this product, always inflate the board. If you notice a significant drop in pressure,
read the "Leak Check" instructions in the Repair section of this manual.
•
Do not overinflate. The maximum recommended pressure is 12 PSI.
•
Do not leave this product in direct sunlight for a long time, when the pressure is at its maximum.
If this product is used in a hot or sunny environment, check the pressure every hour and release air
if it rises. Inflate to correct PSI before use. Water temperature can also cause air loss in the air
chamber. Putting your bike deck in the water for a few minutes can be a good way to adjust it to
its new environment, then check the tube pressure again. It would be a good idea to take a pump
and pressure gauge with you so you can add air to the inner tube if needed.
CAUTION:
Do not leave your board exposed to direct sunlight and if you do, deflate it to avoid
excessive stretching of the material. The ambient temperature affects the pressure level in the inner
tube: a variation of 1°C / 1.8°F causes a pressure variation in the inner tube ± 4mBar (0.06PSI)
12.7
FIN ASSEMBLY:
The fin can be mounted after the board is inflated. The fin is in a case, you can fix it thanks to a corner:
1. Replace the flap on the housing rail.
