Redpath Statesman 2.43m x 3.65m, Инструкции и иллюстрации, Страница: 22 / 27

22
EXTERIOR SINGLE DOOR TRACK
This door track is the same as the partition & bolts to the door track support by inserting bolts into the bolt slot of the door track,
pushing them through the corresponding 3 holes in the door track support, put nuts on and tighten them up. Fit the door, carrying
out the up/down movement previously described to get the correct position in the bottom door guide. Attach the small angle
support to the top right of the right hand roof corner bar. “Fine tune” as before if necessary.
EXTERIOR DOUBLE DOOR TRACK
This fits in exactly the same way as the single door track and is “fine tuned” accordingly. However it has a small angle bracket on
the left hand roof corner bar as well as the right corner bar.
The small glazing bar above the MIDDLE of the door can now be fitted. Put the glazing beading into the grooves and trim to suit.
Insert 2 bolts into the bar and put them through the holes in the top door track and apex gusset plate. Put nuts on and tighten up.
NOW YOU CAN FIT THE VENT TO THE RIDGE
Before sliding the vent into the ridge, slide a piece of black tube into the vent hinge socket. Slide the vent into position, insert a
small self-tapping screw into the tube approximately ½ way along then tighten the screw. The tube will expand and lock into
position thus preventing sideways movement of the vent. N.B. There is no hole for the screw but it will easily push into the tube
and screw up. (Key point)
You only require one tube per vent on the left hand side of the vent socket (viewed from inside the greenhouse).
Having slid the vents form the end of the ridge to the desired position, you can now fit the “slam bars” to the 2 glazing bars. Utilise
the bolts you inserted during general assembly and position the “slam bars” just under the vent allowing the casement stay to
effectively close. The slam bar can be adjusted later to facilitate good opening and closing of the vent.
FITTING THE DOOR TO THE STRUCTURE
The door slides on to the frame from the left hand side.
Put the door bottom rail into the bottom door track and slide to the right, feed the first wheel into the upper door track and move
further to the right until the black draught excluder butts up to the end glazing bars. Carefully ease the door past the glazing bar
and feed in the second wheel. Push further to the right until both draught excluders are butting up to both end-glazing bars.
Carefully ease the door past the two glazing bars. The door will now run quite freely. To square up the door with the spacing,
undo the upper bolts holding the door track. There is a little play to facilitate “fine tuning” of the door.
N.B. sometimes the door can be a little stiff prior to glazing but once the PolyCarb has been inserted (the last job of the
construction) the extra weight will make for smooth running. (Key Point)
Align end of door track with door in fully closed position.
Use slot located under here