Redmond RTP-805, Руководство пользователя

Страница: 10 / 16

10
2. Place the appliance to the dry, solid, horizontal surface. Ensure
the escaping steam does not fall on wallpaper, decorative
coats, electric units and other items, which can be damaged
by steam and high temperature.
3. Unwind the power cord to the desired length. If necessary
use the extender of a suitable power (no less than 2.5 kW).
4. Press the lid latch and pull it up to open the lid.
5. Carefully pour cold water from a jar or other reservoir into
the appliance. The water level must not exceed the FULL
mark. If you fill the appliance with water above the max mark,
it is possible to spray boiling water. If there is too little water,
the appliance may overheat.
Do not pour water directly from the tap so that it does not get
on the electrical contacts inside the appliance. It may lead to
malfunction.
CAUTION! the appliance is to be used only for heating and boil-
ing water.
6. Close the lid of the appliance tightly.
II. OPERATING THE APPLIANCE
Water-temperature maintenance mode
1. Connect the appliance to the mains, it will make a sound, the
display will show the current temperature of water in the
thermopot, the button indicator will flash.
2. Press the button, the button indicator lights up, the
button indicator will be lit constantly.
3. Use the button to select heating with pre-boil ( indi -
cator – recommended when using unfiltered water) or heat-
ing without pre-boiling ( indicator – recommended when
using filtered water).
4. Use the and buttons to set the desired water tempera-
ture (in the range of 45–90 °C, in 5°C increments), the set
temperature indicator will flash. Do not press the buttons on
the control panel until the set temperature and unfiltered
water indicators are continuously lit.
The desired water temperature may be changed at any stage of
the programme.
If the current water temperature in the thermopot is higher than
the set one, five short beeps will sound. The set water temperature
maintaining mode turns on when the water cools down to the
selected value.
5. The water heating process will start, and the heating process
will be displayed on the current temperature digital indicator.
6. After the water boils (when heating with pre-boiling is selected)
or after the set temperature is reached (when heating without
pre-boiling is selected), the thermopot will make five short beeps.
7. If heating without pre-boiling was selected, the set water
temperature maintaining mode will turn on after heating to
the set temperature is completed.
8. If pre-boiling heating has been selected, the set water tem-
perature maintaining mode is enabled when the temperature
of water in the thermopot drops to the set value.
9. To turn off the appliance, press the button, beep will sound,
indicators and the display will go off.