Redmond RMC-M222S-A, Руководство пользователя

Страница: 16 / 24

16
Program Recommendations
for use
Default c
ooking
Time/
Temperature Time range/
interval
W
aiting to ac
cess
to operating
parameters
Time Delay
, h
Keep
W
arm,
h
QUICK
COOK
Quick cooking rice,
fluffy water porridge.
Press “Start” in the
standby mode to start
the program. During
program
The program is auto-
matically disabled af-
ter complete boil-off.
III. COOKING TIPS
General Guidelines
1. For steaming meat, fish, poultry, vegetables and
multicomponent dishes fill the bowl with 600-1000 ml of
water. Position the steaming container inside the appliance.
Measure and prepare ingredients according to the recipe
directions and evenly distribute them inside the container.
Position the bowl inside the appliance. Ensure that it makes
full contact with the heating element. Follow the instructions
indicated in cookbook.
2. For cooking porridges with pasteurized low fat milk we
recommend you do the following:
• rinse grain thoroughly before cooking;
• grease the sides of the bowl with butter;
• follow the proportions suggested in the recipe book, increase
or reduce amount of ingredients proportionally;
• using whole milk dilute it by half with water.
3. When cooking some dishes (e.g. pasta, ravioli, etc.) some foam
can be formed. Open the lid several minutes after adding
ingredients into boiling water to prevent its possible leakage
outside the bowl.
Common Cooking Mistakes and Ways of Solving Them
This table familiarizes you with the practical tips and solutions
to some common problems you may experience when using the
multicooker.
THE DISH IS UNDERCOOKED
Possible causes Solutions
The lid of the device was opened or
was not closed properly, so the
cooking temperature was not high
enough
Try to avoid opening the lid while cooking. Close
the lid until it clicks into place. Make sure that
the rubber sealing ring located on the inner side
of the lid is not deformed or damaged in any way
Cooking temperature was not
observed because the bowl and the
heating element did not fit tightly
There should not be any foreign objects between
the lid and the housing of the device, remove if any.
Always make sure that the heating element is clean
and fits tightly with the bowl before cooking
Wrong ingredients or settings were
chosen. General proportions were not
observed, the foods were cut into
pieces that are a bit too big. Wrong
time settings. Chosen recipe is not
appropriate for the appliance
We recommend that you use recipes adapted for
the device. Choose proven recipes only.
Set the time and cooking program, choose
ingredients, proportions, and the size of pieces
according to the recipe
Steaming: the amount of water in
the bowl is not enough to provide
enough steam density
Use the amount of water recommended. If in
doubt, check the water level while steaming