Redmond RJ-916, Руководство пользователя

Страница: 10 / 12

10
1. Turn off the juicer. Make sure it is disconnected from the mains
and the speed switch is in position 0.
2. Pull the lower part of the clamps and remove them from the
lid. Remove the lid.
3. Take away the separator by gently pulling it up on the edges.
Do not apply excessive force. Soak the separator in water and
detergent for 10 minutes, then rinse it.
4. Remove the processing chamber and the waste container.
Wash them with the plunger and the lid, using non-abrasive
detergents.
DO NOT immerse the housing and power cord into water or rinse
it under running water.
DO NOT use coarse tissues or sponges, abrasive pastes for cleaning.
It is also not recommended to use any chemically aggressive or
other substances, not recommended for use with items which
contact with food.
Add some lemon juice to clean and shine metal parts.
5. Wipe the housing of the appliance with a damp cloth.
Storage and transportation
Before repeated operation or storage completely dry all parts of
the appliance. Store the assembled appliance in a dry, ventilated
place away from heating appliances and direct sunlight.
During transportation and storage, do not expose the device to
mechanical stress, that may lead to damage of the device and/or
violation of the package integrity.
Keep the device package away from water and other liquids.
IV. BEFORE CONTACTING SERVICE
CENTER
Problem Possible cause Solution
Appliance won’t switch
on
Appliance is not plugged in Plug in the appliance
Electrical socket is not
powered
Connect the appliance to a
properly working electrical
socket
Clamps are not closed
After turning off the appliance,
close the clamps
Motor stops while
operating
Overheating protection
tripped
Follow the instructions in the
“Protection system” section
Waste is accumulated in the
processing chamber due to
excessive rotation speed
Clean the processing chamber,
reduce the rotation speed
Waste is accumulated in
the processing chamber
due to excessive pressure
on the plunger
Clean the processing chamber;
do not overload the food supply
chamber with products; reduce
the force when pressing the
plunger.
Pulp is accumulated on
the separator mesh or
gets into the waste con-
tainer with a lot of juice.
Separator is clogged
Clean the separator (see
“Cleaning and Maintenance”
section)
Juice gets out under too
much pressure or leaks
out of the lid
The rotation speed you
have selected is too high Reduce the rotation speed
You apply excessive force
when using the plunger
Reduce the force when using
the plunger
Strong vibration of the
appliance during opera-
tion
Separator is damaged
Check the separator for cracks
or other damage; if any, contact
the service center